Abracon recommends a 4-layer PCB with a solid ground plane on the bottom layer, and a separate power plane for the oscillator circuit. The crystal should be placed close to the IC, and the traces should be kept short and wide to minimize noise and parasitic inductance.
The ACS1006U requires a stable power supply voltage between 1.8V and 3.3V. Ensure that the power supply is decoupled with a 10uF capacitor and a 100nF capacitor in parallel, placed close to the IC. Additionally, the VDD pin should be connected to a clean power source, and the VSS pin should be connected to a solid ground plane.
The maximum frequency deviation of the ACS1006U over temperature and voltage is ±100 ppm. This means that the frequency can deviate by up to ±100 parts per million over the operating temperature range of -40°C to 85°C and the specified voltage range.
No, the ACS1006U is not designed to operate at frequencies higher than 100 MHz. Abracon recommends using a different oscillator IC, such as the ACS1007U or ACS1008U, which are designed for higher frequency applications.
To troubleshoot issues with the ACS1006U, first ensure that the power supply is stable and within the specified range. Check the PCB layout for any noise or parasitic inductance issues. Use an oscilloscope to measure the output frequency and amplitude, and verify that the crystal is properly connected and oscillating. If the issue persists, contact Abracon technical support for further assistance.
Trust Checks
This model has been provided by community users.
Community Provided
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ACS1006U Overview
Use the download button to access the ACS1006U schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ACS10,
or try a keyword search, such as RF/Microwave Antennas
