LEDIL recommends a PCB layout with a large copper area for heat dissipation, and a thermal via array under the LED to reduce thermal resistance. A thermal interface material (TIM) can also be used to improve heat transfer between the LED and the heat sink.
Use a soldering iron with a temperature range of 250-260°C, and apply a small amount of solder paste to the PCB pads. Ensure the LED is aligned properly and avoid applying excessive pressure, which can cause damage to the component.
The recommended drive current is 350mA, and the recommended voltage is 12V. However, it's essential to consult the datasheet and consider factors like ambient temperature, duty cycle, and desired brightness when determining the optimal drive conditions.
Store the LEDs in a dry, cool place, and avoid exposing them to high humidity or moisture. If the LEDs are exposed to moisture, bake them in a dry oven at 60°C for 24 hours to remove any moisture before use.
LEDIL recommends a reflow soldering profile with a peak temperature of 260°C, a dwell time above 220°C of 30-60 seconds, and a cooling rate of 3-5°C/s. Consult the datasheet for more detailed information.
Trust Checks
No trust score is available for this model.
Trust Score Unavailable
Sponsored
C15014_STRADA-2X2-T4-B Overview
Use the download button to access the C15014_STRADA-2X2-T4-B 3D model. You can still request or build the schematic symbol and PCB footprint by using the respective build or request forms on this page.
To find more CAD model downloads similar to this part, try a partial part number search, like C1501,
or try a keyword search, such as Optoelectronic Accessories
