CDP68HC68T1M2Z96 footprint, schematic symbol and 3D model by Renesas Electronics

Symbol

PCB Footprints

3D Models

CDP68HC68T1M2Z96 Details

The recommended oscillator crystal frequency for the CDP68HC68T1M2Z96 is 16 MHz or 20 MHz, depending on the specific application and clock speed requirements.
The WDT on the CDP68HC68T1M2Z96 can be configured using the WDTCSR (Watchdog Timer Control and Status Register). You need to set the WDTCSR.WDE (Watchdog Timer Enable) bit to enable the WDT, and then set the WDTCSR.WDP (Watchdog Timer Prescaler) bits to select the desired timeout period.
The maximum current consumption of the CDP68HC68T1M2Z96 depends on the operating frequency, voltage, and other factors. According to the datasheet, the maximum current consumption is approximately 15 mA at 5V and 16 MHz operating frequency.
The CDP68HC68T1M2Z96 has 1 KB of internal EEPROM. To use it, you need to enable the EEPROM by setting the EECON.EEPE (EEPROM Enable) bit. Then, you can read and write data to the EEPROM using the EECON.EEWE (EEPROM Write Enable) bit and the EEPROM address registers.
The BOD on the CDP68HC68T1M2Z96 is a feature that detects when the supply voltage falls below a certain threshold (typically 4.5V or 4.2V) and resets the microcontroller to prevent malfunction or data corruption. You can configure the BOD threshold and enable/disable it using the BODCSR (Brown-Out Detector Control and Status Register).

Manufacturer Collaborated

System Verified

Community Approved

Use the download button to access the CDP68HC68T1M2Z96 schematic symbol, PCB footprint, and 3D model.

To find more CAD model downloads similar to this part, try a partial part number search, like CDP68, or try a keyword search, such as Timers or RTCs

Showing 0 results


Please enter a minimum 3 letters or numbers
← Prev Next →