CLA4603-085LF footprint, schematic symbol and 3D model by Skyworks

Symbol

PCB Footprints

3D Models

CLA4603-085LF Details

A 4-layer PCB with a solid ground plane and a separate power plane is recommended. The device should be placed near the edge of the board to minimize signal loss. A 50-ohm microstrip transmission line should be used to connect the device to the antenna.
The device requires a 5V power supply and a bias current of 10mA to 20mA. A voltage regulator and a bias resistor network can be used to provide a stable bias voltage. The bias voltage should be decoupled with a 10uF capacitor to reduce noise.
The device can handle a maximum input power of 2W. Exceeding this power limit can cause damage to the device. It is recommended to use an attenuator or a limiter to prevent over-powering the device.
Use a spectrum analyzer to check the output frequency and power level. Verify that the device is properly biased and that the input signal is within the recommended power range. Check for any signs of overheating or physical damage to the device.
Yes, the CLA4603-085LF can be used in a push-pull configuration to improve output power and reduce distortion. However, this requires careful impedance matching and biasing to ensure optimal performance.

Expert Contribution

System Verified

Community Approved

Use the download button to access the CLA4603-085LF schematic symbol, PCB footprint, and 3D model.

To find more CAD model downloads similar to this part, try a partial part number search, like CLA46, or try a keyword search, such as PIN Diodes

If you searched for CLA4603-085LF, you might also be interested in these parts:

Showing 0 results


Please enter a minimum 3 letters or numbers
← Prev Next →