FOXSDLF/200-20 - Fox

FOXSDLF/200-20 Frequently Asked Questions (FAQs)

• What is the recommended power-up sequence for the FOXSDLF/200-20?
  The recommended power-up sequence is to apply VCC before enabling the oscillator output (OE) pin. This ensures proper initialization and prevents unwanted oscillations.
• How do I ensure the FOXSDLF/200-20 oscillator is in a stable state during power-up?
  To ensure a stable state during power-up, add a 10kΩ pull-up resistor between the OE pin and VCC, and a 100nF capacitor between the OE pin and GND. This helps to filter out any noise and ensures a clean power-up sequence.
• What is the maximum frequency deviation I can expect from the FOXSDLF/200-20?
  The maximum frequency deviation is typically ±50 ppm over the operating temperature range of -40°C to +85°C. However, this can vary depending on the specific application and environmental conditions.
• Can I use the FOXSDLF/200-20 in a system with multiple power domains?
  Yes, the FOXSDLF/200-20 can be used in systems with multiple power domains. However, ensure that the oscillator is powered from a stable voltage source, and consider using level shifters or voltage translators if necessary to interface with different power domains.
• How do I troubleshoot issues with the FOXSDLF/200-20 oscillator not oscillating?
  To troubleshoot issues with the oscillator not oscillating, check the power supply voltage, ensure the OE pin is properly connected, and verify that the load capacitance is within the recommended range. Also, check for any noise or interference on the power supply lines or oscillator output.