FT2232HL-REEL footprint, schematic symbol and 3D model by FTDI Chip

Symbol

PCB Footprints

3D Models

FT2232HL-REEL Details

The maximum cable length supported by the FT2232HL-REEL is approximately 3 meters (10 feet) for full-speed devices and 1.5 meters (5 feet) for low-speed devices, assuming a good quality cable with proper shielding and termination.
No, the FT2232HL-REEL is not a USB hub. It is a USB-to-UART/FIFO IC that provides a single USB port and two UART/FIFO interfaces. It does not support multiple downstream USB ports.
The FT2232HL-REEL can be configured for UART or FIFO mode using the MPSSE (Multi-Protocol Synchronous Serial Engine) commands. The device can be configured using the FTDIChip-ID tool or by sending the appropriate MPSSE commands through the USB interface.
The FT2232HL-REEL supports baud rates up to 12 Mbps (million bits per second) for the UART interface and up to 30 Mbps for the FIFO interface.
No, the FT2232HL-REEL is a 3.3V device and should not be powered from a 5V supply. The device has an internal 3.3V regulator, but it is recommended to use an external 3.3V power supply to ensure reliable operation.

Expert Contribution

System Verified

Community Approved

Use the download button to access the FT2232HL-REEL schematic symbol, PCB footprint, and 3D model.

To find more CAD model downloads similar to this part, try a partial part number search, like FT223, or try a keyword search, such as Bus Controllers

If you searched for FT2232HL-REEL, you might also be interested in these parts:

Showing 0 results

Image	Part Number	Model
	FT2232HL-TRAY FTDI Chip USB Bus Controller
For a full list of alternate parts for FT2232HL-REEL, check out Findchips.com


Please enter a minimum 3 letters or numbers
← Prev Next →