The maximum cable length supported by the FT2232HPQ-REEL is approximately 3 meters (10 feet) for full-speed USB and 1.5 meters (5 feet) for low-speed USB, assuming a good quality cable with proper shielding and termination.
No, the FT2232HPQ-REEL is not a USB hub. It is a USB-to-serial/FIFO IC that provides two independent channels, each of which can be configured as a USB-to-serial port, a FIFO interface, or a variety of other modes, but it does not support hub functionality.
The FT2232HPQ-REEL can be configured for I2C or SPI interfaces using the MPSSE (Multi-Protocol Synchronous Serial Engine) mode. This requires writing a specific sequence of commands to the device to set up the clock, data, and control signals. FTDI provides example code and documentation to help with this process.
The power consumption of the FT2232HPQ-REEL depends on the operating mode and clock frequency. In typical USB-to-serial mode, the device consumes around 50-70 mA at 3.3V. In FIFO mode, the power consumption can be as low as 10-20 mA. See the datasheet for more detailed power consumption information.
No, the FT2232HPQ-REEL is a 3.3V device and should not be powered from a 5V supply. The device has an internal 3.3V regulator, but it is not designed to handle 5V input. Using a 5V supply can damage the device.
Trust Checks
This model has been provided by community users.
Community Provided
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
FT2232HPQ-REEL Overview
Use the download button to access the FT2232HPQ-REEL schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like FT223,
or try a keyword search, such as Bus Controllers
