FT2233HPQ-TRAY footprint, schematic symbol and 3D model by FTDI Chip

Symbol

PCB Footprints

3D Models

FT2233HPQ-TRAY Details

The maximum cable length supported by the FT2233HPQ-TRAY is approximately 3 meters (10 feet) for full-speed USB devices and 1.5 meters (5 feet) for low-speed USB devices, assuming a good quality cable with minimal signal attenuation.
No, the FT2233HPQ-TRAY is not a USB hub. It is a USB-to-serial converter that provides two independent UART channels, but it does not support USB hub functionality.
The power consumption of the FT2233HPQ-TRAY depends on the operating mode and the clock frequency. In typical operating conditions, the device consumes around 50-70 mA from the USB bus. However, this can increase to up to 200 mA if the device is operating at high clock frequencies or with high output drive strengths.
Yes, the FT2233HPQ-TRAY can be powered from a 5V power supply, but it is recommended to use a 3.3V power supply to ensure reliable operation and minimize power consumption.
The FT2233HPQ-TRAY can be configured for UART mode using the FTDIChip-ID utility software or by using the MPSSE (Multi-Protocol Synchronous Serial Engine) commands. The device must be configured to use the UART protocol and the desired baud rate, data bits, parity, and stop bits must be set accordingly.

Community Provided

System Verified

Community Approved

Use the download button to access the FT2233HPQ-TRAY schematic symbol, PCB footprint, and 3D model.

To find more CAD model downloads similar to this part, try a partial part number search, like FT223, or try a keyword search, such as Bus Controllers

Showing 0 results


Please enter a minimum 3 letters or numbers
← Prev Next →