NORA-W306-00B - u-blox

NORA-W306-00B Frequently Asked Questions (FAQs)

• What is the recommended power-on sequence for the NORA-W306-00B module?
  The recommended power-on sequence is to first apply the power supply voltage (VCC) and then the backup battery voltage (VBACKUP). This ensures that the module's internal voltage regulators are properly initialized.
• How do I configure the module's UART interface?
  The UART interface can be configured using the AT command set. The default baud rate is 115200, but it can be changed using the AT+IPR command. The module also supports flow control and can be configured for RTS/CTS or XON/XOFF flow control.
• What is the maximum current consumption of the NORA-W306-00B module?
  The maximum current consumption of the module is approximately 450 mA during transmission and 120 mA during reception. However, the average current consumption is typically much lower, around 20-50 mA, depending on the operating mode and signal strength.
• How do I implement antenna diversity with the NORA-W306-00B module?
  The module supports antenna diversity, which can be implemented by connecting two antennas to the module's RF ports (RF1 and RF2). The module can then automatically switch between the two antennas to optimize signal reception.
• What is the operating temperature range of the NORA-W306-00B module?
  The operating temperature range of the module is -40°C to +85°C. However, the module's performance may be affected at extreme temperatures, and it is recommended to operate the module within a temperature range of -20°C to +70°C for optimal performance.