The NUC200VE3AN can operate from -40°C to 105°C, but the recommended operating temperature range is -20°C to 85°C for optimal performance and reliability.
The NUC200VE3AN has an internal oscillator and can also use an external clock source. To configure the clock source, you need to set the CKS (Clock Source Select) bits in the Clock Control Register (CLK_CFG). You can choose from internal high-speed oscillator (HCLK), internal low-speed oscillator (LCLK), or external clock source (EXTCLK).
The maximum current consumption of the NUC200VE3AN depends on the operating frequency and voltage. At 3.3V and 24MHz, the typical current consumption is around 15mA. However, this can increase to around 30mA at 48MHz. It's recommended to check the datasheet for specific current consumption values based on your application's requirements.
The NUC200VE3AN has a built-in watchdog timer (WDT) that can be enabled and configured using the Watchdog Timer Control Register (WDT_CFG). You need to set the WDT enable bit, select the clock source, and set the timeout period. The WDT will reset the microcontroller if it doesn't receive a reset or a watchdog timer clear signal within the specified timeout period.
Yes, the NUC200VE3AN can be used with an external crystal oscillator. You need to connect the crystal oscillator to the XT1 and XT2 pins, and configure the clock source to use the external crystal oscillator. The recommended crystal frequency is between 4MHz and 24MHz.
Trust Checks
This model has been provided by an expert contributor.
Expert Contribution
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
NUC200VE3AN Overview
Use the download button to access the NUC200VE3AN schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like NUC20,
or try a keyword search, such as Microcontrollers
