Description:The RX210 Group has a wide operating voltage range of 1.62 V to 5.5 V and can execute calculations at 78 DMIPS (Dhrystone million instructions per second) at up to 50 MHz high-speed operation. Furthermore, it achieves 0.2 mA/MHz low power performance when operating at 50 MHz. Consumption current in deep software standby mode is a mere 0.45 µA. A wide lineup of 48 KB to 1 MB ROM and 48-pin to 145-pin products is available.
Renesas recommends using a external power-on reset (POR) circuit with a voltage detector (VD) and a reset IC to ensure reliable reset operation. A typical POR circuit consists of a voltage detector (VD) such as the NCP302 or NCP303, a reset IC such as the MCU reset IC (R3160), and a capacitor to filter out noise.
To optimize flash memory programming, use the Renesas Flash Development Toolkit (FDT) which provides a GUI-based interface for programming and verifying the flash memory. Additionally, use the 'Flash Acceleration Mode' feature in the R5F52108CGFP#30 to reduce programming time. This mode allows the MCU to program the flash memory at a higher speed.
The maximum operating frequency of the R5F52108CGFP#30 is 32 MHz. However, the actual operating frequency may be limited by the system clock source, such as the external crystal oscillator or the internal high-speed oscillator (HOCO). Refer to the datasheet for specific clock source limitations.
The R5F52108CGFP#30 has a built-in watchdog timer (WDT) that can be enabled and configured using the WDT control registers. The WDT can be clocked by the internal low-speed oscillator (LOCO) or an external clock source. The WDT timeout period can be set to one of several predefined values, and the WDT can be reset by writing to the WDT control register.
When designing a PCB with the R5F52108CGFP#30, consider the following: keep the power supply lines (VCC and GND) as short and wide as possible, use a solid ground plane, and place decoupling capacitors near the MCU. Additionally, ensure that the clock signal lines are routed away from noisy signals and that the reset signal line is routed to a quiet area of the board.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
R5F52108CGFP#30 Overview
Use the download button to access the R5F52108CGFP#30 schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like R5F52,
or try a keyword search, such as Microcontrollers
