S25FL116K0XNFI011 - Infineon

S25FL116K0XNFI011 Frequently Asked Questions (FAQs)

• What is the maximum operating temperature range for this device?
  The S25FL116K0XNFI011 can operate from -40°C to +125°C, with a maximum junction temperature of 150°C.
• How do I handle the hold signal (HOLD#) during read and write operations?
  The HOLD# signal should be asserted low to pause the current operation, and de-asserted high to resume the operation. Note that HOLD# should not be asserted during power-up or power-down sequences.
• What is the recommended power-up sequence for this device?
  The recommended power-up sequence is to apply VCC first, followed by VPP (if used), and then the clock signal (CLK). The device is ready for operation after a minimum delay of 10 ms.
• How do I determine the device density and configuration?
  The device density and configuration can be determined by reading the Device ID (JEDEC ID) and the Configuration Register (CR). The JEDEC ID is read using the RDID command, and the CR is read using the RDCR command.
• What is the purpose of the Write Protection (WP#) signal?
  The WP# signal is used to protect the status register and the configuration register from being modified. When WP# is asserted low, the registers are write-protected, and when it is de-asserted high, the registers can be modified.