A 4-layer PCB with a solid ground plane and a separate power plane is recommended. The device should be placed near the edge of the board to minimize signal loss. A 50-ohm microstrip transmission line should be used to connect the device to the antenna.
The device requires a 3.3V power supply and a bias current of 10mA. A voltage regulator and a bias resistor network can be used to ensure proper biasing. The bias voltage should be applied to the VCC pin and the bias current should be set using a resistor divider network.
The device can handle a maximum input power of +20 dBm. Exceeding this power level may cause damage to the device or affect its performance.
Common issues include poor impedance matching, incorrect biasing, and thermal issues. Use a network analyzer to check the impedance matching and a thermal camera to check for thermal issues. Verify the bias voltage and current using a multimeter.
Yes, the device can be used in a switching application. However, the switching frequency should be limited to 100 kHz to avoid self-oscillation. A series resistor and a shunt capacitor can be used to improve the switching performance.
Trust Checks
This model has been provided by community users.
Community Provided
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
SMV1130-079LF Overview
Use the download button to access the SMV1130-079LF schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like SMV11,
or try a keyword search, such as Varactors
