A good PCB layout for the ZLLS350TA involves keeping the input and output traces separate, using a solid ground plane, and minimizing the length of the input and output traces. Additionally, it's recommended to use a 10uF capacitor between the VIN and GND pins to filter out noise.
To ensure the ZLLS350TA operates within its SOA, monitor the input voltage, output current, and junction temperature. Make sure the input voltage is within the recommended range (4.5V to 18V), the output current is within the maximum rating (3.5A), and the junction temperature is below 125°C.
The recommended input capacitor value is 10uF to 22uF, and the type should be a low-ESR ceramic capacitor (e.g., X5R or X7R) to minimize voltage ripple and ensure stable operation.
The output voltage of the ZLLS350TA can be calculated using the following formula: VOUT = (R1 / R2) * (VIN - VREF), where R1 and R2 are the feedback resistors, VIN is the input voltage, and VREF is the internal reference voltage (1.25V).
The EN (enable) pin is used to turn the regulator on or off. To use it, connect the EN pin to a logic signal (e.g., from a microcontroller) to enable or disable the regulator. When the EN pin is high, the regulator is enabled, and when it's low, the regulator is disabled.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ZLLS350TA Overview
Use the download button to access the ZLLS350TA schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ZLLS3,
or try a keyword search, such as Rectifier Diodes
Suggested Parts
If you searched for ZLLS350TA, you might also be interested in these parts:
