A 4-layer PCB with a solid ground plane and a separate power plane is recommended. The device should be placed near the edge of the board to minimize signal reflections. A 50-ohm microstrip transmission line should be used to connect the device to the antenna.
The device requires a single 3.3V power supply. A 10uF capacitor should be connected between the VCC pin and ground to filter out noise. A 1kohm resistor should be connected between the EN pin and VCC to enable the device.
The device is rated for operation from -40°C to 85°C. However, the optimal operating temperature range is between 0°C to 70°C for maximum performance and reliability.
Use a spectrum analyzer to check the transmitted signal spectrum and ensure it meets the required specifications. Check the device's power supply and biasing to ensure they are within the recommended range. Use a logic analyzer to verify the device's control signals.
Yes, the device can be used in a multi-module configuration. However, each module should have its own power supply and biasing circuitry. The modules should be spaced at least 10mm apart to minimize electromagnetic interference.
Trust Checks
No trust score is available for this model.
Trust Score Unavailable
Sponsored
AFBR-5803Z Overview
Use the download button to access the AFBR-5803Z 3D model. You can still request or build the schematic symbol and PCB footprint by using the respective build or request forms on this page.
To find more CAD model downloads similar to this part, try a partial part number search, like AFBR-,
or try a keyword search, such as Fiber Optic Transceivers
Suggested Parts
If you searched for AFBR-5803Z, you might also be interested in these parts:
