HSMH-C110 footprint, schematic symbol and 3D model by Avago Technologies

Symbol

PCB Footprints

3D Models

HSMH-C110 Details

Broadcom recommends a 4-layer PCB with a solid ground plane and thermal vias to dissipate heat. A thermal pad on the bottom of the package should be connected to a thermal plane on the PCB.
Use a low-noise, high-PSRR power supply with a minimum of 1A current capability. Decouple the power pins with 10uF and 100nF capacitors, and add a 10uF capacitor on the AVDD pin.
Use a single 25MHz clock input, and let the internal PLL generate the required clock frequencies. Ensure the clock signal has a low jitter and is routed close to the device.
Use a reset IC or a discrete reset circuit with a 10kΩ pull-up resistor and a 100nF capacitor. Ensure the reset signal is active-low and has a minimum pulse width of 10ms.
Configure the GPIO pins as inputs or outputs according to the application requirements. Use pull-up or pull-down resistors as needed, and ensure the GPIO pins are not left floating.

Expert Contribution

System Verified

Community Approved

Use the download button to access the HSMH-C110 schematic symbol, PCB footprint, and 3D model.

To find more CAD model downloads similar to this part, try a partial part number search, like HSMH-, or try a keyword search, such as Visible LEDs

If you searched for HSMH-C110, you might also be interested in these parts:

Showing 0 results

Image	Part Number	Model
	HSMH-C110 Broadcom Limited Single Color LED, Red, Clear Untinted Nondiffused
	HSMH-C110 Agilent Technologies Inc Single Color LED, Red, Diffused
For a full list of alternate parts for HSMH-C110, check out Findchips.com


Please enter a minimum 3 letters or numbers
← Prev Next →