Description:The ISL12026 and the ISL12026A devices are micro power real time clocks with timing and crystal compensation, clock/calender, power-fail indicator, two periodic or polled alarms, intelligent battery backup switching, and integrated 512x8-bit EEPROM configured in 16 Bytes per page. The oscillator uses an external, low-cost 32. 768kHz crystal. The real time clock tracks time with separate registers for hours, minutes, and seconds. The device has calendar registers for date, month, year and day of the week. Th
A good PCB layout for the ISL12026IBZ involves keeping the analog and digital grounds separate, using a solid ground plane, and placing the device close to the crystal oscillator. Additionally, it's recommended to use a low-ESR capacitor for the VCC pin and to minimize the length of the clock signal traces.
To ensure the accuracy of the RTC, it's essential to use a high-quality crystal oscillator with a low ppm tolerance, maintain a stable power supply voltage, and minimize temperature variations. Additionally, the device should be calibrated periodically to account for any drift in the crystal oscillator frequency.
The ISL12026IBZ can drive a clock output frequency up to 32.768 kHz, which is the typical frequency of a watch crystal oscillator. However, the device can also be configured to drive higher frequencies, up to 1 MHz, depending on the specific application requirements.
The battery switchover function in the ISL12026IBZ can be handled by connecting the primary battery to the VBAT pin and the secondary battery to the VBAT_SW pin. The device will automatically switch to the secondary battery when the primary battery voltage falls below a certain threshold. The threshold voltage can be adjusted by connecting a resistor divider network to the VBAT_SW pin.
The TRIM pin on the ISL12026IBZ is used to adjust the internal oscillator frequency. By connecting a resistor or a capacitor to the TRIM pin, the oscillator frequency can be fine-tuned to compensate for any deviations from the nominal frequency. The TRIM pin can be used to adjust the frequency by ±20 ppm.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ISL12026IBZ Overview
Use the download button to access the ISL12026IBZ schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ISL12,
or try a keyword search, such as Timers or RTCs
Suggested Parts
If you searched for ISL12026IBZ, you might also be interested in these parts:
