BS66F360 - Holtek

BS66F360 Frequently Asked Questions (FAQs)

• What is the recommended oscillator crystal frequency for the BS66F360?
  The recommended oscillator crystal frequency for the BS66F360 is 12 MHz or 24 MHz, depending on the application and clock speed requirements.
• How do I configure the BS66F360's UART for 9-bit data transmission?
  To configure the BS66F360's UART for 9-bit data transmission, set the UART control register (UCR) to enable 9-bit mode, and adjust the baud rate generator (BRG) accordingly. Refer to the datasheet for specific register settings.
• Can I use the BS66F360's internal oscillator as a clock source for the UART?
  No, the internal oscillator is not recommended as a clock source for the UART. Instead, use an external crystal oscillator or a high-accuracy clock source to ensure reliable UART communication.
• How do I implement a watchdog timer (WDT) on the BS66F360?
  To implement a WDT on the BS66F360, enable the WDT by setting the WDT control register (WDTCR), and configure the WDT timeout period using the WDT timer register (WDTR). The WDT will reset the microcontroller if the timer expires without being cleared or reset.
• What is the maximum current consumption of the BS66F360?
  The maximum current consumption of the BS66F360 varies depending on the operating frequency, voltage, and peripheral usage. However, according to the datasheet, the typical current consumption is around 10 mA at 5V and 12 MHz.