For optimal performance, it's recommended to follow a 4-layer PCB stack-up with a solid ground plane, and to use thermal vias to dissipate heat. A minimum of 1 oz copper thickness is recommended. Additionally, ensure a minimum of 10 mm clearance around the device for airflow and heat dissipation.
To ensure accurate current measurement, ensure the CT2002-0 is installed in a way that minimizes external magnetic interference. Use a twisted pair for the current sense lines, and keep them away from high-current carrying wires. Also, calibrate the device according to the datasheet instructions.
A 2-stage RC filter with a cutoff frequency of 10 kHz is recommended to filter out high-frequency noise and ensure accurate measurements. The filter should be placed as close to the CT2002-0 as possible.
The CT2002-0 has an internal overcurrent detection circuit. In the event of an overcurrent condition, the device will output a fault signal. It's recommended to implement an external overcurrent protection circuit to disconnect the load in case of an overcurrent event.
Calibration should be performed at room temperature (25°C) with a known current source. Apply a series of known currents to the device and measure the output voltage. Use a linear regression analysis to determine the calibration coefficients.
Trust Checks
No trust score is available for this model.
Trust Score Unavailable
Sponsored
CT2002-0 Overview
Use the download button to access the CT2002-0 3D model. You can still request or build the schematic symbol and PCB footprint by using the respective build or request forms on this page.
To find more CAD model downloads similar to this part, try a partial part number search, like CT200,
or try a keyword search, such as Other Interconnects
