Description:The EL5175 and EL5375 are single and triple high bandwidth amplifiers designed to extract the difference signal from noisy environments. They are primarily targeted for applications such as receiving signals from twisted-pair lines or any application where common mode noise injection is likely to occur. The EL5175 and EL5375 are stable for a gain of one and requires two external resistors to set the voltage gain for each channel. The output common mode level is set by the reference pin (VREF), which has a -
A good PCB layout for the EL5175IYZ-T13 involves keeping the input and output traces short and separate, using a solid ground plane, and placing decoupling capacitors close to the device. Additionally, it's recommended to use a 4-layer PCB with a dedicated power plane and a dedicated ground plane to minimize noise and EMI.
To ensure proper powering and decoupling, connect the VCC pin to a clean, low-impedance power source, and use a 0.1uF to 1uF decoupling capacitor between VCC and GND, placed as close to the device as possible. Additionally, consider adding a 10uF to 22uF bulk capacitor to the power supply line to filter out noise and ripple.
The EL5175IYZ-T13 has an operating temperature range of -40°C to +125°C, but it's recommended to operate the device within a temperature range of -20°C to +85°C for optimal performance and reliability.
To handle ESD protection, use a static-dissipative workstation, wear an ESD strap, and handle the device by the body or pins, avoiding direct contact with the die. Additionally, consider adding ESD protection diodes or TVS devices to the input and output pins to protect against electrostatic discharge.
The recommended input signal amplitude for the EL5175IYZ-T13 is between 100mV to 1V, and the frequency range is up to 100MHz. However, the specific input signal requirements may vary depending on the application, so it's essential to consult the datasheet and application notes for more information.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
EL5175IYZ-T13 Overview
Use the download button to access the EL5175IYZ-T13 schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like EL517,
or try a keyword search, such as Line Driver or Receivers
