Description:The ISL3159E is a ±15kV IEC61000 ESD protected, 5V powered, single transceiver that meets both the RS-485 and RS-422 standards for balanced communication. It also features the larger output voltage and higher data rate (up to 40Mbps) required by high speed PROFIBUS applications, and is offered in industrial and extended Industrial (-40°C to +125°C) temperature ranges. The low bus currents (+220µA/-150µA) present a “1/5 unit load” to the RS-485 bus. This allows up to 160 transceivers on the network without v
A good PCB layout for the ISL3159EIBZ-T involves keeping the analog and digital grounds separate, using a solid ground plane, and minimizing the length of the traces between the device and the capacitors. Additionally, it's recommended to use a 4-layer PCB with a dedicated power plane and a dedicated ground plane.
To ensure proper powering and decoupling of the ISL3159EIBZ-T, use a high-quality power supply with low ripple and noise, and decouple the device with a 10uF capacitor between VCC and GND, and a 100nF capacitor between AVCC and AGND. Additionally, use a 1uF capacitor between the VCC pin and the power plane.
The maximum cable length supported by the ISL3159EIBZ-T depends on the specific application and the type of cable used. However, as a general guideline, the device can support cable lengths of up to 100 meters for RS-485 and up to 1 kilometer for RS-422. It's recommended to use a cable with a characteristic impedance of 120 ohms and a twisted pair construction.
To troubleshoot common issues with the ISL3159EIBZ-T, start by checking the power supply and decoupling, then verify the signal integrity and termination. Use an oscilloscope to check the signal waveforms and ensure they are within the specified limits. Also, check the device's operating temperature and ensure it is within the recommended range.
Yes, the ISL3159EIBZ-T can be used in a multi-point or multi-drop configuration. However, it's recommended to use a repeater or a hub to ensure signal integrity and to prevent signal degradation. Additionally, ensure that the total cable length and the number of devices on the bus do not exceed the recommended limits.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ISL3159EIBZ-T Overview
Use the download button to access the ISL3159EIBZ-T schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ISL31,
or try a keyword search, such as Line Driver or Receivers
