Description:The Renesas ISL317xE are ±15kV IEC61000 ESD protected, 3. 3V powered single transceivers that meet both the RS-485 and RS-422 standards for balanced communication. These devices have very low bus currents (+125µA/-100µA), so they present a true “1/8 unit load” to the RS-485 bus. This allows up to 256 transceivers on the network without violating the RS-485 specification's 32 unit load maximum, and without using repeaters. For example, in a remote utility meter reading system, individual meter readings are r
Renesas provides a recommended PCB layout in the ISL3171EIUZ evaluation board user manual, which includes guidelines for component placement, routing, and thermal management to ensure optimal performance and minimize noise.
To ensure reliable operation in high-temperature environments, it is recommended to follow the thermal management guidelines in the datasheet, including using a heat sink, thermal interface material, and ensuring good airflow. Additionally, consider using a thermistor or temperature sensor to monitor the device temperature and implement thermal shutdown or throttling if necessary.
The maximum cable length for the RS-485 bus depends on the data rate, cable characteristics, and noise environment. As a general guideline, Renesas recommends a maximum cable length of 4000 feet (1219 meters) at a data rate of 10 Mbps. However, it is recommended to perform signal integrity analysis and testing to determine the maximum cable length for a specific application.
To implement fault tolerance and error detection in an RS-485 design, consider using techniques such as checksums, cyclic redundancy checks (CRCs), and error-correcting codes. Additionally, implement fault detection mechanisms such as bus fault detection, receiver timeout, and transmitter timeout. The ISL3171EIUZ also provides a fault detection pin that can be used to detect bus faults and errors.
The ISL3171EIUZ has built-in ESD protection diodes on the RS-485 pins, which can withstand electrostatic discharges up to ±15 kV. Additionally, the device is designed to prevent latch-up, a condition where a device becomes stuck in a high-current state, by using a latch-up prevention circuit. However, it is still recommended to follow proper ESD handling and prevention procedures during device handling and PCB assembly.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ISL3171EIUZ Overview
Use the download button to access the ISL3171EIUZ schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ISL31,
or try a keyword search, such as Line Driver or Receivers
