Description:The ISL6522 provides complete control and protection for a DC-DC converter optimized for high-performance microprocessor applications. It is designed to drive two N-Channel MOSFETs in a synchronous rectified buck topology. The ISL6522 integrates all of the control, output adjustment, monitoring and protection functions into a single package. The output voltage of the converter can be precisely regulated to as low as 0.8V, with a maximum tolerance of ±1% over temperature and line voltage variations. The ISL6
The recommended PCB layout for optimal performance involves keeping the input and output capacitors close to the IC, using a solid ground plane, and minimizing the length of the traces between the IC and the capacitors. Additionally, it's recommended to use a separate power plane for the input and output voltages to reduce noise and EMI.
To ensure the stability of the output voltage, it's essential to choose the correct output capacitor value and type. The datasheet recommends a minimum output capacitance of 10uF, and a low-ESR capacitor is recommended to reduce output voltage ripple. Additionally, the output voltage can be stabilized by adding a feedback capacitor between the FB pin and the output voltage.
Although the datasheet specifies a maximum input voltage of 28V, it's recommended to derate the input voltage to 25V to ensure reliable operation and to prevent damage to the IC. Applying an input voltage above 25V may cause the IC to overheat or fail.
The power dissipation of the IC can be calculated using the formula: Pd = (Vin - Vout) x Iout x Efficiency. The efficiency of the IC can be obtained from the datasheet, and the input and output voltages and currents can be measured or calculated based on the application. It's essential to ensure that the power dissipation does not exceed the maximum rating specified in the datasheet.
The EN (Enable) pin is used to enable or disable the IC. When the EN pin is pulled high, the IC is enabled, and when it's pulled low, the IC is disabled. The EN pin can be used to implement power sequencing, shutdown, or low-power standby modes in the system. It's recommended to use a pull-up resistor to ensure the EN pin is at a valid logic level.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ISL6522CRZ-TK Overview
Use the download button to access the ISL6522CRZ-TK schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ISL65,
or try a keyword search, such as Switching Regulator or Controllers
