Description:The ISL6730A, ISL6730B, ISL6730C, ISL6730D are active Power Factor Correction (PFC) controller ICs that use a boost topology. The controllers are suitable for AC/DC power systems, up to 2kW and over the universal line input. The ISL6730A, ISL6730B, ISL6730C, ISL6730D operate in Continuous Conduction Mode (CCM). Accurate input current shaping is achieved with a current error amplifier. A patent pending breakthrough negative capacitance technology minimizes zero crossing distortion and reduces the magnetic co
The recommended PCB layout for the ISL6730DFUZ-T involves placing the input capacitors close to the VIN pin, using a solid ground plane, and keeping the high-current paths short and wide. Additionally, it's recommended to use a 4-layer PCB with a dedicated power plane and a dedicated ground plane to minimize noise and EMI.
The selection of input and output capacitors for the ISL6730DFUZ-T depends on the specific application requirements. In general, it's recommended to use low-ESR capacitors with a high ripple current rating. The input capacitor should be able to handle the input voltage and current, while the output capacitor should be able to handle the output voltage and current. A good starting point is to use a 10uF to 22uF input capacitor and a 22uF to 47uF output capacitor.
The ISL6730DFUZ-T can operate in an ambient temperature range of -40°C to +85°C. However, the device's performance and reliability may be affected at higher temperatures, and it's recommended to derate the device's power handling capability at temperatures above 70°C.
The ISL6730DFUZ-T has a built-in overcurrent protection feature that can be enabled by connecting the OCP pin to a resistor and capacitor network. The OCP threshold can be set by selecting the appropriate resistor value. Additionally, the device also has a hiccup mode that can be enabled to limit the output current during an overcurrent condition.
Yes, the ISL6730DFUZ-T can be used in a synchronous buck converter configuration. In this configuration, the device's internal high-side FET is used as the main switch, and an external low-side FET is used as the synchronous rectifier. This configuration can improve the converter's efficiency and reduce the output voltage ripple.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ISL6730DFUZ-T Overview
Use the download button to access the ISL6730DFUZ-T schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ISL67,
or try a keyword search, such as Switching Regulator or Controllers
