PS2501-1-H-A footprint, schematic symbol and 3D model by Renesas Electronics

Symbol

PCB Footprints

3D Models

PS2501-1-H-A Details

A 4-layer PCB with a solid ground plane and a separate power plane is recommended. Keep the analog and digital grounds separate and connect them at a single point. Use a 10uF capacitor between VCC and GND, and a 100nF capacitor between AVCC and AGND.
Use a metal shield or a shielded enclosure to reduce electromagnetic radiation. Ensure proper grounding and decoupling of the device. Use a common-mode choke or a ferrite bead to filter the power supply lines.
Power up the device in the following sequence: VCC, AVCC, and then the input voltage (VIN). Ensure that the power supplies are stable before applying the input voltage.
Use a heat sink or a thermal pad to dissipate heat. Ensure good airflow around the device. Avoid blocking the airflow or using a metal can that can trap heat.
The recommended input voltage range is 2.7V to 5.5V. However, the device can operate with an input voltage as low as 2.3V, but with reduced performance.

Community Provided

System Verified

Community Approved

Use the download button to access the PS2501-1-H-A schematic symbol, PCB footprint, and 3D model.

To find more CAD model downloads similar to this part, try a partial part number search, like PS250, or try a keyword search, such as Optocoupler

If you searched for PS2501-1-H-A, you might also be interested in these parts:

Showing 0 results


Please enter a minimum 3 letters or numbers
← Prev Next →