SiTime recommends a 4-layer PCB with a dedicated ground plane, and to keep the oscillator away from high-frequency signals and noise sources. A good layout should also minimize the distance between the oscillator and the crystal, and use a ground plane under the oscillator to reduce noise.
The SIT8924BA-73-18E-25.000000G requires a stable power supply with minimal noise and ripple. Ensure the power supply voltage is within the recommended range of 1.8V to 3.3V, and use a low-dropout regulator (LDO) or a dedicated voltage regulator module (VRM) to minimize power supply noise.
The SIT8924BA-73-18E-25.000000G has a CMOS output stage, and SiTime recommends a 10kΩ to 20kΩ pull-up resistor to VCC, and a 10pF to 100pF capacitor to ground for proper signal termination.
To minimize EMI and ensure EMC, use a shielded enclosure, keep the oscillator away from antennas and high-frequency sources, and use a common-mode choke or ferrite bead on the power supply lines. Additionally, ensure the PCB layout is designed to minimize radiation and susceptibility to external interference.
Handle the SIT8924BA-73-18E-25.000000G with electrostatic discharge (ESD) precautions, such as using an ESD wrist strap or mat. Store the oscillator in a dry, cool place, away from direct sunlight and moisture. Avoid bending or flexing the leads, and use a vacuum-sealed package or airtight container for long-term storage.
Trust Checks
This model has been provided by an expert contributor.
Expert Contribution
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
SIT8924BA-73-18E-25.000000G Overview
Use the download button to access the SIT8924BA-73-18E-25.000000G schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like SIT89,
or try a keyword search, such as XO
