A good PCB layout for the SP3490CN-L should ensure that the analog and digital grounds are separated, and the analog ground is connected to the digital ground at a single point. Additionally, the layout should minimize noise coupling between the analog and digital sections, and ensure that the power supply decoupling capacitors are placed close to the device.
The SP3490CN-L requires a single 3.3V power supply, and it's recommended to use a low-dropout linear regulator (LDO) to power the device. Decoupling capacitors of 10uF and 0.1uF should be placed close to the device, with the 10uF capacitor connected between the power pin and the analog ground, and the 0.1uF capacitor connected between the power pin and the digital ground.
The SP3490CN-L is capable of transmitting data at rates up to 921.6 kbps, but the actual data rate may be limited by the specific application, cable length, and noise environment.
The SP3490CN-L can be configured for half-duplex or full-duplex operation by setting the appropriate control signals. For half-duplex operation, the RTS (Request to Send) signal should be connected to the CTS (Clear to Send) signal, and for full-duplex operation, the RTS signal should be connected to a separate output, and the CTS signal should be connected to a separate input.
The maximum cable length supported by the SP3490CN-L depends on the specific application, data rate, and cable characteristics. As a general guideline, the device can support cable lengths up to 100 meters at lower data rates, but the actual cable length may be limited by the specific application and noise environment.
Trust Checks
This model has been provided by community users.
Community Provided
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
SP3490CN-L Overview
Use the download button to access the SP3490CN-L schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like SP349,
or try a keyword search, such as Line Driver or Receivers
