The W25Q64JVSTIQ has a minimum of 100,000 erase cycles per sector, and a total of 20,000,000 erase cycles for the entire device.
The HOLD# pin should be pulled high during power-up and power-down to prevent any unwanted commands from being executed. It's recommended to connect a pull-up resistor to VCC and a capacitor to GND to ensure a clean signal.
The W25Q64JVSTIQ supports clock frequencies up to 104 MHz. However, it's recommended to use a clock frequency of 50 MHz or lower to ensure reliable operation and to minimize power consumption.
The WP# pin should be pulled high during normal operation to enable write operations. If the WP# pin is pulled low, the device will be in a write-protected state, and any write operations will be ignored.
The QPI mode allows the W25Q64JVSTIQ to operate in a quad-bus mode, where four data lines are used to transfer data simultaneously. This mode can increase the data transfer rate and improve system performance.
Trust Checks
No trust score is available for this model.
Trust Score Unavailable
Sponsored
W25Q64JVSTIQ Overview
Use the download button to access the W25Q64JVSTIQ 3D model. You can still request or build the schematic symbol and PCB footprint by using the respective build or request forms on this page.
To find more CAD model downloads similar to this part, try a partial part number search, like W25Q6,
or try a keyword search, such as Flash Memories
