Description:The X9317 is a digitally controlled potentiometer (XDCP™). The device consists of a resistor array, wiper switches, a control section, and nonvolatile memory. The wiper position is controlled by a 3-wire interface. The potentiometer is implemented by a resistor array composed of 99 resistive elements and a wiper switching network. Between each element and at either end are tap points accessible to the wiper terminal. The position of the wiper element is controlled by the CS, U/D, and INC inputs. The positio
Renesas provides a recommended layout and routing guide in their application note (Renesas Document No. AP6073). It's essential to follow this guide to ensure proper operation and minimize noise and interference.
The X9317WS8Z has an internal POR and BOR circuit. To handle these, ensure a proper power-up sequence, and use an external capacitor (e.g., 10uF) between VCC and GND to filter out noise. Also, consider adding an external reset circuit if your application requires a more robust reset mechanism.
The maximum allowed voltage on the input pins is VCC + 0.5V. Exceeding this voltage may cause damage to the device. Ensure that input signals are properly clamped or use voltage-limiting resistors to prevent overvoltage.
The X9317WS8Z has a built-in WDT. To implement it, configure the WDT registers (e.g., WDTCR, WDTCSR) according to the datasheet, and ensure that the WDT is periodically reset or reloaded to prevent a timeout. You can also use an external WDT circuit if required.
The X9317WS8Z has a maximum junction temperature (TJ) of 150°C. Ensure proper thermal design, including heat sinking, thermal vias, and adequate airflow to keep the device within the recommended operating temperature range.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
X9317WS8Z Overview
Use the download button to access the X9317WS8Z schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like X9317,
or try a keyword search, such as Digital Potentiometers
