Description:The Renesas ISL317xE are ±15kV IEC61000 ESD protected, 3. 3V powered single transceivers that meet both the RS-485 and RS-422 standards for balanced communication. These devices have very low bus currents (+125µA/-100µA), so they present a true “1/8 unit load” to the RS-485 bus. This allows up to 256 transceivers on the network without violating the RS-485 specification's 32 unit load maximum, and without using repeaters. For example, in a remote utility meter reading system, individual meter readings are r
A good PCB layout for the ISL3171EIBZ-T involves keeping the analog and digital grounds separate, using a solid ground plane, and placing the device close to the power supply. Additionally, it's recommended to use a low-ESR capacitor for the VCC pin and to minimize the length of the traces connected to the RX and TX pins.
To ensure reliable operation in high-temperature environments, it's essential to follow proper thermal management practices. This includes providing adequate heat sinking, using a thermally conductive PCB material, and keeping the device away from heat sources. Additionally, the device should be operated within its specified temperature range (-40°C to +125°C).
Operating the ISL3171EIBZ-T at a lower supply voltage than the recommended 3.3V may result in reduced performance, increased power consumption, and potential reliability issues. Operating at a higher supply voltage may cause the device to exceed its maximum ratings, leading to permanent damage. It's recommended to operate the device within the specified supply voltage range (2.7V to 3.6V) for optimal performance and reliability.
To troubleshoot issues with the UART interface, start by verifying the device's configuration and settings. Check the baud rate, data bits, parity, and stop bits to ensure they match the requirements of the connected device. Use a logic analyzer or oscilloscope to monitor the UART signals and identify any errors or anomalies. Additionally, ensure that the device is properly powered and that the UART pins are not overloaded or short-circuited.
The ISL3171EIBZ-T has built-in ESD protection on all pins, which can withstand electrostatic discharges up to ±8kV according to the IEC 61000-4-2 standard. To prevent latch-up, it's recommended to follow proper PCB design practices, such as using a solid ground plane, minimizing trace lengths, and avoiding parallel signal paths. Additionally, ensure that the device is operated within its specified voltage and current ratings.
Trust Checks
This model has been built in collaboration with the manufacturer.
Manufacturer Collaborated
This model has been verified by system checks.
System Verified
This model has been reviewed by community users.
Community Approved
Sponsored
ISL3171EIBZ-T Overview
Use the download button to access the ISL3171EIBZ-T schematic symbol, PCB footprint, and 3D model.
To find more CAD model downloads similar to this part, try a partial part number search, like ISL31,
or try a keyword search, such as Line Driver or Receivers
