A 4-layer PCB with a solid ground plane and a separate power plane is recommended. Keep the analog and digital grounds separate and connect them at a single point. Use a decoupling capacitor (e.g., 10uF) close to the VCC pin.
Use a soft-start circuit to slowly ramp up the power supply voltage (VCC) to the recommended operating voltage (3.3V or 5V) within 10ms. Avoid sudden power-on or power-off, as it may cause damage to the device.
The power supply lines should be kept as clean as possible. The maximum allowed noise is 100mVpp. Use a low-ESR capacitor (e.g., 10uF) close to the VCC pin to filter out high-frequency noise.
The BH76806FVM-TR has a thermal pad on the bottom of the package. Ensure good thermal conductivity by using a thermal interface material (e.g., thermal tape or thermal grease) between the thermal pad and a heat sink or a metal plate on the PCB.
The clock signal should have a frequency of 32.768kHz with a duty cycle of 50% ±10%. The clock signal amplitude should be between 0.5V and VCC. Use a clock signal with low jitter (less than 100ps) to ensure accurate timing.
Trust Checks
No trust score is available for this model.
Trust Score Unavailable
Sponsored
BH76806FVM-TR Overview
Use the download button to access the BH76806FVM-TR 3D model. You can still request or build the schematic symbol and PCB footprint by using the respective build or request forms on this page.
To find more CAD model downloads similar to this part, try a partial part number search, like BH768,
or try a keyword search, such as Audio/Video Amplifiers
